MC605V D

Initialization

1. 1. Switch function/three-stage dimming function: the light will be turned on 100% brightness by the initial energizing sensor, and will be turned off after 10 seconds. During initialization, no external motion sensing signal will be detected.
2. Two-phase dimming function: the light will turn on 100% brightness in the initial energizing sensor, and turn to low brightness 10 seconds later (the brightness set by stand-by dim level). During initialization, no external motion sensing signal will be detected.

Factory setting

Detection Area: 100%,  Hold Time: 5S,  Daylight Sensor: Disable,  Stand-by Period: 0S,  Dimming brightness preset function: 50%

Application notice

• The sensor should be installed by a professional electrician. Please turn off the power before installing, wiring, changing the setting of the DIP switch.
• The sensor which installed in the plastic and glass lampshade will reduce the sensitivity.For every 3mm increase in thickness, the sensitivity will be reduced by 20%.
• The light sensitivity threshold is in a sunny environment, no shadow and ambient light diffuse reflection..Ambient lux level could be different in different environment, weather, climate, time-of-day and season.
• The parameters of the sensor may need to be reconfigured in differentinstallation environments.
• This sensor is for indoor use only. It will affect the waterproof effect for outdoor Wind, rain, and moving objects around will cause false triggering.
• The distance between any inductive sensors should be greater than 3m.
• Do not place the sensor close to high-density objects such as metal, glass,concrete walls, etc, false triggering could happen. When the sensor isinstalled in a metal lamp, metal reflective surface, or a narrow enclosed environment, the microwave will be reflected repeatedly and cause false triggering. Please reduce the sensitivity or contact the manufacturer for technical support.
• Please ensure that there are no moving signals around the sensor, such as fan,DC motor, sewer pipe, air outlet, etc., the sensor may generate false trigger.
• The data on detection pattern is typical value tested without any lighting fixture in Merrytek factory, the detection range could be affected by moving speed, installation height, motion object and different environment.
• You are advised to test 5 samples before mass application of sensor in a newlighting project.
• Due to continuous improvement, the contents of this instruction could bechanged without prior notice.