MC098S F1

Initialization

After power on, the sensor automatically turns on light at 100% brightness. After 10sec, it turns off the light. During the initialization, the sensor is not able to detect movement.

Factory Setting

Detection area: 100%,    Hold Time: 5S,    Daylight Sensor: Disable

Application Notice

• The sensor should be installed by a professional electrician. Please turn off thepower before installing, wiring, changing the setting of the DIP switch.
• Microwave can not penetrate metal, please avoid the product installed in closed or semi-closed metal lamps, ensure that there is no metal or glass cover above the product; If the antenna must pass through the metal plate, ensure that the top of the sensor is pressed against the metal plate
• The installation distance between microwave sensors is recommended to be biggerthan 1.5m, and it should be far away from switches, routers and other wireless devices to avoid radio interference. The installation distance between the two is recommended to be greater than 1.5m; The antenna surface of the microwave sensor must be far away from the input AC and output DC to avoid interference from low or high frequency signals.
• Should avoid microwave sensor surrounding long-term vibration equipment or moving objects, the vibration signal will be regarded as mobile signal trigger induction, so the installation position should be far away from large metal equipment, ventilation pipes, air conditioning outlets, exhaust vents, smoke exhaust machine and other scenes; If a pet passes through the detection area, it may trigger the sensor.
• This product is suitable for indooruse only, semi-outdoor or outdoor installation, wind, rain may be regarded as mobile signal trigger induction; When the sensor is installed in metal lamps, metal reflective surface or narrow closed environment, the microwave will be reflected many times and trigger by mistake. Please reduce the sensitivity of the sensor or contact the manufacturer for technical support.
• The sensor is better for ceiling mounting. If wall installation is used, the detection distance of microwave induction will be increased, which may lead to the phenomenon of microwave penetrating the wall or not putting out the lamp. Under this case, pls try to lower the sensitivity, If 25% cannot be used, avoid wall mounting or contact the manufacturer for technical support.
• Product specifications and parameters may be optimized without prior notice.
• The product sensing distance and the moving speed of the object, the size of the object, the installation height of the product, the installation Angle, the installation environment, reflective material and other factors related.
• The detection distances showedin the specifications are typical values obtained by 165cm high testers in an indoor open environment.
• If the antenna must pass through the metal plate, the hole should be no less than 20*8mm, and the top of the sensor must be close to the metal plate; The antenna is exposed at the opening, and the top of the sensor shell is close to the metal plate.
• This product is suitable for indooruse only, semi-outdoor or outdoor installation, wind, rain may be regarded as mobile signal trigger induction; When the sensor is installed in metal lamps, metal reflective surface or narrow closed environment, the microwave will be reflected many times and trigger by mistake. Please reduce the sensitivity of the sensor or contact the manufacturer for technical support.
• The sensor is better for ceiling mounting. If wall installation is used, the detection distance of microwave induction will be increased, which may lead to the phenomenon of microwave penetrating the wall or not putting out the lamp. Under this case, pls try to lower the sensitivity, If 25% cannot be used, avoid wall mounting or contact the manufacturer for technical support.
• Product specifications and parameters may be optimized without prior notice.
• The product sensing distance and the moving speed of the object, the size of the object, the installation height of the product, the installation Angle, the installation environment, reflective material and other factors related.
• The detection distances showedin the specifications are typical values obtained by 165cm high testers in an indoor open environment.
• If the antenna must pass through the metal plate, the hole should be no less than 20*8mm, and the top of the sensor must be close to the metal plate; The antenna is exposed at the opening, and the top of the sensor shell is close to the metal plate.